Enter/Exit Programming Mode
Image Capture to the Host by Camera Button
Perform the following steps to set up the Camera Button.
1. Set the Camera Button Mode to enabled.
2. Set the Image Capture destination to host port.
3. Press the camera button.
Scanner will beep for a few seconds, then take picture and send the Image
Retrieval Event label to the POS to indicate image is ready. The data content of
the event label is:
The POS sends the picture retrieval command to initiate picture download from
the scanner. Format of the command is:
The scanner sends the picture to the POS with the transmission format
described in the previous section, "Image Capture By Host Command".
Camera Button Mode
This feature enables or disables the camera button.
DEFAULT
05B001(CR)
Camera Button Mode = Enable
38
A856102000239
P\x02pG
Image Capture to the Host by Camera Button
05B000(CR)
Camera Button Mode = Disabled
Magellan™ 3450VSi