Step 5 - Test Mode - Datalogic DS2100N Reference Manual

RAPID CONFIGURATION
STEP 5 – TEST MODE
Use a code suitable to your application to test the system. Alternatively, you can use the
Datalogic Test Chart (Code 39, Code Interleaved 2/5).
1. Enter the Test mode function by holding the X-PRESS™ push button pressed until the
TEST LED is on.
2. Release the button to enter the Test mode function.
Once entered, the Bar-Graph on the five LEDs is activated and if the scanner starts
reading barcodes the Bar-Graph shows the Good Read Rate. In case of no read
condition, only the STATUS LED is on and blinks.
3. To exit the Test Mode, press the X-PRESS™ push button once.
By default, the Test Mode exits automatically after two minutes.
NOTE
SETUP
LEARN
TEST
Figure 9 – X-PRESS™ Interface: Test Mode Function
READY
green
GOOD
green
TRIGGER
yellow
COM
yellow
STATUS
red
1
13