Good Read Beep Volume
Good Read Beep Volume
Selects the beeper volume upon a good read beep. There are five selectable
volumes, with each volume increment adding approximately five decibels to the
previous level:
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You'll need to cover any unused bar
3. Complete the programming sequence by scanning the Enter/Exit Programming
001901(CR)
Good Read Beep Volume = Medium Low
DEFAULT
001903(CR)
Good Read Beep Volume = Medium High
Product Reference Guide
•
Low
•
Medium Low
•
Medium
codes on this and the facing page to ensure that the scanner reads only the bar
code you intend to scan.
Mode bar code.
Enter/Exit Programming Mode
•
Medium High
•
High
001900(CR)
Good Read Beep Volume = Low
001902(CR)
Good Read Beep Volume = Medium
001904(CR)
Good Read Beep Volume = High
31