1
STEP 9 – TEST MODE
Use a code suitable to your application to test the reading performance of the system.
1.
Enter the Test function by pressing and holding the X-PRESS™ push button until the
Test LED is on.
2.
Release the button to enter the Test function.
Once entered, the Bar Graph on the five LEDs is activated and when codes are placed
in the reading area (FOV), the Bar-Graph shows the Good Read Rate. In case of no
read condition, only the STATUS LED is on and blinks.
3.
To exit the Test, press the X-PRESS™ push button once.
By default, the Test exits automatically after three minutes.
NOTE
The Bar Graph has the following meaning:
18
red
yellow yellow green green
STATUS
COM
TRIGGER
TEST
Figure 15 – X-PRESS™ Interface: Test Function
20%
40%
STATUS
COM
TRIGGER
TEST
MATRIX 450™ REFERENCE MANUAL
GOOD
READY
FOCUS
SETUP
LEARN
60%
75%
95%
GOOD
READY
FOCUS
SETUP
LEARN