Single Cable Rs-232 Use Etx; Set Single Cable Rs-232 Etx Character - Datalogic Magellan 3450VSi Product Reference Manual

Single Cable RS-232 Features

Single Cable RS-232 Use ETX

Enables/disables the ability of the scanner to use ETX..
048001(CR)
Single Cable RS-232 Use ETX = Enable

Set Single Cable RS-232 ETX Character

Allows selection of the ETX character. To specify the ETX Character:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code,
3. Scan the appropriate characters/digits from the
4. The scanner will automatically exit Programming Mode when the appro-
DEFAULT
Product Reference Guide
Set Single Cable RS-232 ETX Character
need to cover any unused bar codes on this and the facing page to ensure
the scanner reads only the bar code you intend to scan.
Appendix C that represent the decimal designation for the desired charac-
ter. A table containing the ASCII Character Set and their corresponding
decimal values is available in the inside back cover of this manual. ASCII
parameters must be input by scanning decimal digits for each character.
Pad all numbers with leading zeroes to yield a three-digit entry (001-127).
Thus, to set a single character value of A, bar codes containing the digits
'0', '6' and '5' must be scanned. The selectable range for this option is any
decimal value from 001 to 127.
priate amount of digits have been scanned.
Enter/Exit Programming Mode
048000(CR)
Single Cable RS-232 Use ETX = Disable
DEFAULT
Alpha-Numeric Keypad in
047A(CR)
Set Single Cable RS-232 ETX Character
Default setting for this feature is:
00D - CR
below. You'll
83