Set Single Cable Rs-232 Stx Character - Datalogic Magellan 3450VSi Product Reference Manual

Enter/Exit Programming Mode

Set Single Cable RS-232 STX Character

This feature selects the STX character.
To specify the STX Character:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code,
3. Scan the appropriate characters/digits from the
4. The scanner will automatically exit Programming Mode when the appro-
DEFAULT
82
Set Single Cable RS-232 STX Character
need to cover any unused bar codes on this and the facing page to ensure
the scanner reads only the bar code you intend to scan.
Appendix C that represent the decimal designation for the desired charac-
ter. A table containing the ASCII Character Set and their corresponding
decimal values is available in the inside back cover of this manual. ASCII
parameters must be input by scanning decimal digits for each character.
Pad all numbers with leading zeroes to yield a three-digit entry (001-127).
Thus, to set a single character value of A, bar codes containing the digits
'0', '6' and '5' must be scanned. The selectable range for this option is any
decimal value from 001 to 127.
priate amount of digits have been scanned.
Single Cable RS-232 Use STX
Alpha-Numeric Keypad in
0479(CR)
Set Single Cable RS-232 STX Character
Default setting for this feature is:
053 - S
below. You'll
Magellan™ 3450VSi