Double Read Timeout - Datalogic Magellan 3450VSi Product Reference Manual

Enter/Exit Programming Mode
1D Double Read Timeout
The 1D Double Read Timeout feature specifies the minimum allowable time
which must pass before reading the same 1D label again (e.g. two identical
items in succession).
To set the Double Read Timeout:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You'll need to cover any
3. Complete the programming sequence by scanning the Enter/Exit Programming
004D28(CR)
1D Double Read Timeout = 400ms
004D50(CR)
1D Double Read Timeout = 800ms
12
SCANNING FEATURES
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
Mode bar code.
If the incidence of multiple reads is not acceptable, increase the
Double Read Timeout setting to a higher value.
NOTE
1D Double Read Timeout
004D1E(CR)
1D Double Read Timeout = 300ms
DEFAULT
004D3C(CR)
1D Double Read Timeout = 600ms
Magellan™ 3450VSi