Digital Watermark (Dwm) Double Read Timeout - Datalogic Magellan 3450VSi Product Reference Manual

Digital Watermark (DWM) Features

Digital Watermark (DWM) Double Read Timeout

Specifies the minimum allowable time which must pass before reading the
same Digital Watermark (DWM) label again (e.g. two identical items in succes-
sion).
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan your selection from the bar codes below. You'll need to cover any
Complete the programming sequence by scanning the Enter/Exit Programming
Mode bar code.
005228(CR)
DWM Double Read Timeout = 0.4 Seconds
DEFAULT
005246(CR)
DWM Double Read Timeout = 0.7 Seconds
Product Reference Guide
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
If the incidence of multiple reads is not acceptable, increase the
Double Read Timeout setting to a higher value.
NOTE
Enter/Exit Programming Mode
00521E(CR)
DWM Double Read Timeout = 0.3 Seconds
005232(CR)
DWM Double Read Timeout = 0.5 Seconds
005264(CR)
DWM Double Read Timeout = 1 Second
15