Enter/Exit Programming Mode
RS-232 ACK Character
This feature specifies which ASCII character will be used as an ACK character.
To specify the RS-232 ACK Character:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code, SET RS-232 ACK Character below. You'll need to cover
3. Scan the appropriate digits from the
4. The scanner will automatically exit Programming Mode when the appro-
DEFAULT
70
DO NOT set this feature to use previously defined char-
acters such as XON, XOFF or host commands as this will
conflict with normal operation of these characters. 8-bit
data is not recognized when the feature, RS-232 Num-
NOTE
ber of Data Bits, is set to 7 data bits.
any unused bar codes on this and the facing page to ensure the scanner
reads only the bar code you intend to scan.
that represent the hex designation for the desired character. A table con-
taining the ASCII Character Set and their corresponding Hex Values is
available in the inside back cover of this manual. ASCII parameters must be
input by scanning a pair of hexadecimal digits for the desired character.
For example, if ASCII "A" were the desired ACK character, you would scan
the digits "4", then "1" (the ASCII corresponding hex value).
priate amount of digits/characters have been scanned.
RS-232 ACK NAK Features
Alpha-Numeric Keypad in Appendix C
031F(CR)
Set RS-232 ACK Character
Default setting for this feature is:
06
Magellan™ 3450VSi