Label Id - Datalogic Magellan 3450VSi Product Reference Manual

Label ID

5. Scan the END bar code once to finish the string, then scan END again to
NOTE
6. The resulting message string would appear as follows:
Label ID
A Label ID is used to identify a bar code (symbology) type. See
Factory Default
appended previous to or following the transmitted bar code data depending
upon how this option is enabled. This feature provides options for configuring
custom Label IDs individually per symbology. If you wish to program the scan-
ner to always include an industry standard label identifier for ALL symbology
types, see the feature,
The Label ID is a customizable code of up to three ASCII characters (each of
which are 00-7F) followed by a control character (00-01), This control charac-
ter, when set to zero, does nothing. When set to one, it appends the symbol-
ogy's AIM ID to the Label ID.
NOTE
To configure a Label ID:
1. Scan the Enter/Exit Programming Mode bar code.
2. Select Label ID position as either BEFORE or AFTER by scanning the appro-
3. Scan a bar code to select the symbology for which you wish to configure a
4. Determine the desired character(s) (you may choose up to three) which will
5. Turn to
6. Scan the END bar code to exit programming mode.
282
tion code, scan the '2' and '4' bar codes from
Keypad.
exit Programming Mode.
If all 20 characters will be used in the prefix or suffix, do not scan the END bar
code to finish the string. It is done automatically.
Scanned bar code data:12345
Resulting message string output: $12345
Settings, for a listing for common symbologies. It can be
AIM ID
When the control character is set to 01 for UPC-A and UPC-E, it expands the
label to EAN-13 and thus follows the EAN-13 Label ID settings.
priate bar code.
custom Label ID.
represent the Label ID for the selected symbology. Next, turn to the
Character Set on page i
the equivalent hex digits associated with your choice of Label ID. For
example, if you wish to select an equal sign (=) as a Label ID, the chart
indicates its associated hex characters as 3D.
Appendix C and scan the bar codes representing the hex charac-
ters determined in the previous step. For example, to make an equal sign
(=), scan '3' and 'D' followed by '0' six times. Since this is a three-charac-
ter buffer, '00' is scanned for character two, '00' for character three and
'00' for the control character. ('00' indicates no character.)
on page 2-101.
on the inside back cover of this manual and find
Appendix C, Alpha-Numeric
Appendix D,
Magellan™ 3450VSi
ASCII