Usb Keyboard Send Control Characters - Datalogic Magellan 3450VSi Product Reference Manual

USB Keyboard Features

USB Keyboard Send Control Characters

This feature specifies how the scanner transmits ASCII control characters to the
host.
Choices are:
Disable —
Enable transmission of control characters to host —
the host.
Send characters between 00H and 1FH —
according to special function-key mapping table (This is used to send keys that
are not in normal ASCII set; a unique set is provided for each available scancode
set).
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code for the desired setting below. You'll need to cover any
3. Complete the programming sequence by scanning the Enter/Exit Pro-
DEFAULT
02C501(CR)
Keyboard Send Control Characters =
Enable transmission of control characters to host
Product Reference Guide
Affects suffix and prefix characters. When disabled, only ASCII
characters between 20H and 127H inclusive (space... delete)
plus special characters 0DH (carriage return), 08H (backspace),
27H (ESC), 09H (right tab) and 0BH (left tab) are transmitted.
NOTE
No control characters are sent to the host.
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
gramming Mode bar code.
Enter/Exit Programming Mode
Control characters are sent to
Send characters between 00H and 1FH
02C500(CR)
Keyboard Send Control Characters = Disable
02C502(CR)
USB Keyboard No Keyboard Support =
Send characters between 00H and 1FH
93