Standard 2 Of 5 Check Character Calculation - Datalogic Magellan 3450VSi Product Reference Manual

Enter/Exit Programming Mode

Standard 2 of 5 Check Character Calculation

Enables/disables calculation and verification of an optional Standard 2 of 5
check character.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable bar code below. You'll need to cover any
3. Complete the programming sequence by scanning the ENTER/EXIT Pro-
DEFAULT
049601(CR)
Standard 2 of 5 Check Character Calculation = Enable
248
If check character calculation is disabled, the risk is increased that
a misread can occur. When disabled, any check character in a bar
code is treated as data character.
NOTE
unused bar codes on this and the facing page to ensure that the scanner
reads only the bar code you intend to scan.
gramming Mode bar code.
Standard 2 of 5 Check Character Calculation
049600(CR)
Standard 2 of 5 Check Character Calculation = Disable
Magellan™ 3450VSi