Enter/Exit Programming Mode
Maximum Host-Transmitted Message Length
Specifies the maximum number of data characters allowed in messages trans-
mitted to the host.
To set the Maximum Host-Transmitted Message Length:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code,
3. Scan the appropriate digits from the
4. The scanner will automatically exit Programming Mode when the appro-
DEFAULT
60
INTERFACE FEATURES
Set Maximum Host-Transmitted Message Length on
page 60
below. You'll need to cover any unused bar codes on this and the
facing page to ensure that the scanner reads only the bar code you intend
to scan.
that represent the desired maximum host-transmitted message length.
The selectable range is 0-249 data characters. (Labels that are longer than
this length are not read.) Pad all single and double digit numbers with
leading zeroes to yield a three-digit entry (000-249).
If this configuration item is set to 0 (000), there is no general
length limit imposed on data being transmitted to the host.
NOTE
priate amount of digits have been scanned.
Maximum Host-Transmitted Message Length
Keypad on page 461
06B1(CR)
Set Maximum Host-Transmitted Message Length
Default setting for this feature is:
000 - No general limit imposed
in
Appendix C
Magellan™ 3450VSi