To Set The Line Voltage - HP 1660CS-Series User Manual

To set the line voltage

When shipped from HP, the line voltage selector is set and an appropriate
fuse is installed for operating the instrument in the country of destination.
Electrostatic discharge can damage electronic components. Use grounded
C A U T I O N
wrist straps and mats when performing any service to the logic analyzer.
Turn the power off, then remove the power cord from the instrument.
1
Remove the fuse module by carefully prying at the top center of the
2
fuse module until you can grasp it and pull it out by hand.
Reinsert the fuse module with the arrow for the appropriate line
3
voltage aligned with the arrow on the line filter assembly switch.
Reconnect the power cord and turn the instrument on.
4
Preparing For Use
To set the line voltage
12-5