Table of Contents
Advertisement
To apply power
Check that the line voltage selector, located on the rear panel, is on the correct
1
setting and the correct fuse is installed.
See also, "To set the line voltage" on this page.
Connect the power cord to the instrument and to the power source.
2
This instrument is equipped with a three-wire power cable. When connected to an
appropriate AC power outlet, this cable grounds the instrument cabinet. The type of power
cable plug shipped with the instrument depends on the country of destination. Refer to
chapter 7, "Replaceable Parts," for option numbers of available power cables and plug
configurations.
Turn on the instrument power switch located on the bottom of the front panel.
3
To operate the user interface
To select a field on the logic analyzer screen, use the arrow keys to highlight the
field, then press the Select key. For more information about the logic analyzer
interface, refer to the HP 1660-Series Logic Analyzer User's Guide.
To set the HP-IB address or to configure for RS-232-C, refer to the HP 1660-Series
Logic Analyzer User's Guide.
To set the line voltage
When shipped from HP, the line voltage selector is set and an appropriate fuse is installed for
operating the instrument in the country of destination. To operate the instrument from a
power source other than the one set, perform the following steps.
Turn the power switch to the Off position, then remove the power cord from the
1
instrument.
Remove the fuse module by carefully prying at the top center of the fuse module
2
until you can grasp it and pull it out by hand.
Preparing for Use
To apply power
2–3
Advertisement
Table of Contents
