Installation; Introduction; Initial Inspection; Preparation For Use - HP 5004A Operating And Service Manual

INTRODUCTION

2-2. This section provides information for inspection, installation, and prepration for use of
the 5004A Signature Analyzer.
2-4. Inspect the shipping container for damage. If the shipping container or cushioning
material i s damaged, it should be kept until the contents of the shipment have been checked
for completeness and the instrument has been checked mechanically and electrically. The
contents of the shipment should be a s shown in Figure 7-7; procedures for checking electrical
performance are given in Section IV. If the contents are incomplete, if there i s mechanical
damage or defect, or if the 5004A does not pass the performance tests, notify the nearest Hewlett-
Packard office. If the shipping container is damaged, or the cushioning material shows signs
of stress, notify the carrier a s well a s the Hewlett-Packard office. Keep the shipping materials
for carrier's inspection. The HP office will arrange for repair or replacement at HP option with-
out waiting for claim settlement.
2-5.

PREPARATION FOR USE

2-6.

Power Requirements

2-7. The 5004A requires a power source a s shown in Section I, Specifications.
2-8.

Line Voltage Selection

2-9. Changing the 5004A power sourcevoltagesetting requires the 5004A cabinet to beopened.
Instructions for changing the line voltage setting are given in Section V.
2-10.

Line Voltage Label

2-11. The original line voltage setting for each 5004A a s manufactured is printed on a label on
the back panel of each 5004A. Check this label and compare the voltage (100,120,220, or 240)
with your local line voltage supply. If you do not have the correct line voltage for your 5004A,
notify a qualified technician and refer to Section V of this manual.
2-12.

Power Cable

2-13. The 5004A is shipped with a three-wire power cable. When the cable is connected to an
appropriate ac power source, this cable grounds internal "grounds" in the 5004A and the two
exposed screws on the rear panel heat sink. The type of power cable plug shipped with each
instrument depends on the country of destination. Refer to Figure 2-7 for the part numbers
of the power cable and plug configurations available.
SECTION II

INSTALLATION

Model 5004A