Mlag Commands - Dell N1100-ON Reference Manual

MLAG Commands

Dell EMC Networking N2000/N2100-ON/N3000/N3100-ON/N4000
Series Switches
MLAG enables a LAG to be created across two independent switches, so that
some member ports of a MLAG can reside on one switch and the other
members of a MLAG can reside on another switch. The partner switch on the
remote side can be a MLAG-unaware unit. To the MLAG unaware switch, the
MLAG appears to be a single LAG connected to a single switch.
NOTE: This feature is not available on the N3000 when loaded with the
AGGREGATION ROUTER-enabled firmware (e.g., N3000_BGPvA.B.C.D.stk).
Commands in this Section
This section explains the following commands:
clear vpc statistics
feature vpc
peer detection enable
peer detection interval
peer-keepalive destination
peer-keepalive enable
peer-keepalive timeout
role priority
show vpc
show vpc brief
clear vpc statistics
Use the clear vpc statistics command to clear the counters for the keepalive
messages transmitted and received by the MLAG switch.
Syntax
clear vpc statistics {peer-keepalive | peer-link}
show vpc consistency-parameters
show vpc consistency-features
show vpc peer-keepalive
show vpc role
show vpc statistics
system-mac
system-priority
vpc
vpc domain
vpc peer-link
Layer 2 Switching Commands
580