Match Dstl4Port - Dell N1100-ON Reference Manual

Table of Contents

Advertisement

match dstl4port

Use the match dstl4port command in Class-Map Configuration mode to add
a match condition based on the destination layer 4 port of a packet using a
single keyword or a numeric notation.
This command is not available on the N1500 Series switches.
NOTE:
Syntax
match dstl4port {portkey | port-number}
portkey — Specifies one of the supported port name keywords. A match
condition is specified by one layer 4 port number. The currently supported
values are: domain, echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp, and
www.
port-number — Specifies a layer 4 port number (Range: 0–65535).
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays adding a match condition based on the
destination layer 4 port of a packet using the "echo" port name keyword.
console(config-classmap)#match dstl4port echo
match ethertype
Use the match ethertype command in Class-Map Configuration mode to add
a match condition based on the value of the ethertype.
This command is not available on the N1500 Series switches.
NOTE:
Layer 2 Switching Commands
686

Advertisement

Table of Contents
loading

This manual is also suitable for:

N1500N3100-onN4000N2100-onN2000N3000

Table of Contents