Dell N1100-ON Reference Manual page 177

Command
clear ipv6 statistics
ipv6 address
ipv6 enable
ipv6 hop-limit
ipv6 host
ipv6 mld last-member-
query-count
ipv6 mld last-member-
query-interval
ipv6 mld host-proxy
ipv6 mld host-proxy reset-
status
ipv6 mld host-proxy
unsolicit-rprt-interval
ipv6 mld query-interval
ipv6 mld query-max-
response-time
ipv6 nd dad attempts
Description
Clears IPv6 statistics for all interfaces or for a
specific interface, including loopback and
tunnel interfaces.
Configures an IPv6 address on an interface
(including tunnel and loopback interfaces).
Enables IPv6 routing on an interface
(including tunnel and loopback interfaces)
that has not been configured with an explicit
IPv6 address.
Configures the hop limit used in IPv6 PDUs
originated by the router.
Defines static host name-to-IPv6 address
mapping in the host cache.
Sets the number of listener-specific queries
sent before the router assumes that there are
no local members on the interface.
Sets the last member query interval for the
MLD interface, which is the value of the
maximum response time parameter in the
group specific queries sent out of this
interface.
Enables MLD Proxy on the router.
Resets the host interface status parameters of
the MLD Proxy router.
Sets the unsolicited report interval for the
MLD Proxy router.
Sets the MLD router's query interval for the
interface.
Sets MLD querier's maximum response time
for the interface.
Sets the number of duplicate address
detection probes transmitted while doing
neighbor discovery.
Dell EMC Networking CLI
a
Mode
PE
IC
IC
GC
GC
IC (VC)
IC (VC)
IC
IC
IC
IC
IC
IC
177