Table of Contents
Advertisement
•
DHCP Rate Limit – excessive DHCP packets detected
•
Loop Protection – A loop was detected by the CTP protocol
•
Multicast Storm – multicast storm detected
•
Port security – port security violation detected
•
SFP Mismatch – unsupported transceiver detected
•
SFP Plus Mismatch –SFP+ transceiver detected in SFP port
•
UDLD – UDLD disabled interface
•
Unicast Storm – unicast storm detected
Command History
Introduced in version 6.2.0.1 firmware.
Updated in version 6.3.0.1 firmware.
Example
The following example shows the output for a 1G interface:
console#show interfaces gi1/0/1
Interface Name : .............................. Gi1/0/1
SOC Hardware Info :............................ BCM56342_A0
Link Status : ................................. Up/Up
Keepalive Enabled.............................. TRUE
Err-disable Cause : ........................... None
VLAN Membership Mode: ......................... Trunk Mode
VLAN Membership: .............................. (1),2-3,101-113,813,3232
MTU Size : .................................... 1518
Port Mode [Duplex] : .......................... Full
Port Speed : .................................. 1000
Link Debounce Flaps : ......................... 0
Auto-Negotation Status : ...................... Auto
Burned MAC Address : .......................... 001E.C9DE.B110
L3 MAC Address................................. 001E.C9DE.B112
Sample load interval : ........................ 300
Received Input Rate Bits/Sec : ................ 784
Received Input Rate Packets/Sec : ............. 1
Transmitted Input Rate Bits/Sec : ............. 1344
Transmitted Input Rate Packets/Sec : .......... 1
Total Packets Received Without Errors.......... 102792
Unicast Packets Received....................... 0
Multicast Packets Received..................... 102792
Layer 2 Switching Commands
395
Advertisement
Table of Contents
