Table of Contents
Advertisement
Default Configuration
The snooping querier is configured to not participate in the querier election
by default.
Command Mode
Global Configuration mode
User Guidelines
If the switch detects another querier in the VLAN, it will cease sending
queries for the querier timeout period.
Example
The following example configures the snooping querier to participate in the
querier election on VLAN 10.
console(config)#ip igmp snooping querier election participate 10
ip igmp snooping querier query-interval
This command sets the IGMP Querier Query Interval time, which is the
amount of time in seconds that the switch waits before sending another
periodic query. The no form of this command sets the IGMP Querier Query
Interval time to its default value.
Syntax
ip igmp snooping querier query-interval interval-count
no ip igmp snooping querier query-interval
•
interval–count — Amount of time in seconds that the switch waits before
sending another general query. (Range: 1-1800)
Default Configuration
The query interval default is 60 seconds.
Command Mode
Global Configuration mode
Layer 2 Switching Commands
483
Advertisement
Table of Contents
