Ignore - Dell N1100-ON Reference Manual

ignore

Use this command to set the switch to ignore certain authentication
parameters from dynamic RADIUS clients. Use the no form of the command
to restore checking of the specific authentication parameters as configured by
the auth-type command.
Syntax
ignore {session-key | server-key}
no ignore {session-key | server-key}
• Session-key—Do not attempt to authenticate with the session key.
• Server-key—Do not attempt to authenticate with the server key.
Default Configuration
The default is to authenticate using the parameters as specified by the
configured auth-type.
Command Modes
Dynamic Radius Configuration
User Guidelines
This command specifies the attributes to validate before acting on a CoA or
disconnect request. If session-key is specified and the session ID is valid,
authentication succeeds even if the session-key does not match.
The ignore command refines the all parameter to limit the attribute
matching.
Setting the auth-type to session-key in conjunction with setting the ignore
session-key is invalid and causes all configured servers to authenticate with no
warnings.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-radius-da)# ignore session-key
Security Commands
972