Table of Contents
Advertisement
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command
Example
console(config)#ip arp inspection validate src-mac dst-mac ip
console(config)#ip arp inspection validate src-mac ip
console(config)#ip arp inspection validate dst-mac ip
console(config)#ip arp inspection validate ip
ip arp inspection vlan
Use the ip arp inspection vlan command to enable Dynamic ARP Inspection
on a single VLAN or a range of VLANs. Use the no form of this command to
disable Dynamic ARP Inspection on a single VLAN or a range of VLANs.
Syntax
ip arp inspection vlan vlan-list [logging]
no ip arp inspection vlan vlan-list [logging]
•
vlan-list —A list of VLAN identifiers. List separate, non-consecutive
VLAN IDs separated by commas (without spaces). Use a hyphen to
designate a range of IDs. (Range: 1–4093)
•
logging — Use this parameter to enable logging of invalid packets.
Default Configuration
Dynamic ARP Inspection is disabled by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Layer 2 Switching Commands
376
Advertisement
Table of Contents
