Table of Contents
Advertisement
Default Configuration
E-mail alerting is disabled by default. When e-mail alerting is enabled, log
messages at or above severity Warning are e-mailed.
Command Mode
Global Configuration mode
User Guidelines
The logging email command with no arguments enables e-mail alerting.
Specify a severity to set the severity level of log messages that are e-mailed in
a non-urgent manner. Log messages at or above this severity level, but below
the urgent severity level, are collected together until the log time expires (the
time specified in the
single e-mail message. If you set the non-urgent severity level to the same
value as the urgent severity level, then no log messages are e-mailed non-
urgently. See the
level. The command no logging email disables all e-mail alerting.
logging email urgent
Use the logging email urgent command in Global Configuration mode to set
the lowest severity level at which log messages are e-mailed in an urgent
manner. To revert the urgent severity level to its default value, use the no
form of this command.
Syntax
logging email urgent {severity | none}
no logging email urgent
•
severity—If you specify a severity level, log messages at or above the
severity level are e-mailed. The severity level may either be specified by
keyword or as an integer from 0 to 7. The accepted keywords, and the
numeric severity level each represents, are as follows.
–
emergency (0)
–
alert (1)
–
critical (2)
logging email logtime
logging email urgent
command) and then e-mailed in a
command to specify the urgent severity
Security Commands
892
Advertisement
Table of Contents
