Table of Contents
Advertisement
[routing] [fragments] [dscp dscp]}} [time-range time-range-name] [log]
[assign-queue queue-id] [{mirror | redirect} interface-id] [rate-limit rate
burst-size]
no [sequence-number]
•
sequence-number — Identifies the order of application of the permit/deny
statement. If no sequence number is assigned, permit/deny statements are
assigned a sequence number beginning at 1000 and incrementing by 10.
Statements are applied in hardware beginning with the lowest sequence
number. Sequence numbers only have applicability within an access group,
i.e. the ordering applies within the access-group scope. The range for
sequence numbers is 1– 2147483647.
•
{deny | permit}–Specifies whether the IP ACL rule permits or denies the
matching traffic.
•
{ipv6-protocol | number| every }—Specifies the protocol to match for the
IP ACL rule.
–
IPv6 protocols: icmpv6, ipv6, sctp, tcp and udp
Every: Match any protocol (don't care)
–
•
source-ipv6-prefix/prefixlength | any | host src-ipv6-address—Specifies a
source IP address and netmask to match for the IP ACL rule.
–
For IPv6 ACLs, "any" implies a 0::/128 prefix and a mask of all ones.
–
Specifying "host X::X" implies a prefix length as "/128" and a mask of
0::/128.
•
[{range {portkey | startport} {portkey | endport} | {eq | neq | lt | gt}
{portkey | 0-65535}]—Specifies the layer 4 destination or source port
match condition for the IP/TCP/UDP ACL rule. A source or destination
port number, which ranges from 0-65535, can be entered, or a portkey,
which can be one of the following keywords: bgp, domain, echo, ftp, ftp-
data, http, ntp, pop2, pop3, rip, smtp, snmp, telnet, tftp, telnet, time, who
and www. Each of these keywords translates into its equivalent destination
port number.
–
When "range" is specified, IPv6 ACL rule matches only if the layer 4
port number falls within the specified port range. The startport and
endport parameters identify the first and last ports that are part of the
port range. They have values from 0 to 65535. The ending port must
Layer 2 Switching Commands
499
Advertisement
Table of Contents
