Name (Vlan Configuration) - Dell N1100-ON Reference Manual

Command Mode
Global Configuration mode
User Guidelines
The VLANs in the interface range must by configured and enabled for
routing prior to use in the vlan range command. Commands used in the
interface range context are executed independently on each interface in the
range. If the command returns an error on one of the interfaces, an error
message is displayed and execution continues on other interfaces.
Example
The following example groups VLAN 221 through 228 and VLAN 889 to
execute the commands entered in interface range mode.
dellswitch(config)#vlan 2-5
dellswitch(config-vlan2-5)#exit
dellswitch(config)#interface vlan 2
dellswitch(config-if-vlan2)#interface vlan 3
dellswitch(config-if-vlan3)#interface vlan 4
dellswitch(config-if-vlan4)#interface vlan 5
dellswitch(config-if-vlan5)#interface range vlan 2-5
dellswitch(config-if)#

name (VLAN Configuration)

Use the name command in VLAN Configuration mode to configure the
VLAN name. To return to the default configuration, use the no form of this
command.
NOTE: This command cannot be configured for a range of interfaces (range
context).
Syntax
name vlan–name
no name
• vlan–name—The name of the VLAN. Must be 1–32 characters in length.
Default Configuration
The default VLAN name is default.
Layer 2 Switching Commands
792