Table of Contents
Advertisement
Loop Protection
Dell EMC Networking N1100-ON/N1500/N2000/N2100-
ON/N3000/N3100-ON/N4000 Series Switches
Loop protection detects physical and logical loops between Ethernet ports on
a device. Loop protection must be enabled globally before it can be enabled at
the interface level.
Commands in this Section
This section explains the following commands:
keepalive (Interface Config)
keepalive (Global Config)
keepalive action
keepalive (Interface Config)
Use the keepalive command in Interface Configuration mode to enable loop
protection on an interface. Use the no form of the command to return the
configuration to the defaults.
Syntax
keepalive
no keepalive
Default Configuration
Loop protection is disabled globally by default and disabled on all interfaces
by default.
Command Mode
Interface (Physical) Configuration mode
show keepalive
show keepalive statistics
–
Layer 2 Switching Commands
573
Advertisement
Table of Contents
