Table of Contents
Advertisement
mvr type
Use the mvr type command in Interface Configuration mode to set the MVR
port type. Use the no form of this command to set the MVR port type to
None.
Syntax
mvr type {receiver | source}
no mvr type
•
receiver—Configure the port as a receiver port. Receiver ports are ports
over which multicast data will be sent but not received.
•
source—Configure the port as a source port. Source ports are ports over
which multicast data is received or sent.
Default Configuration
The default value is None.
Command Mode
Interface Configuration
User Guidelines
The following table lists the completion messages.
Message Type
Successful Completion Message
Error Completion Message
Example
console(config)#mvr
console(config)#mvr group 239.1.1.1
console(config)#vlan 99
console(config-vlan99)#exit
console(config)#interface Gi1/0/1
console(config-if-Gi1/0/1)#switchport access vlan 10
console(config-if-Gi1/0/1)#mvr
Message Description
None
• Port is a Trunk port, operation failed.
• Receiver port in mVLAN, operation failed.
Layer 2 Switching Commands
610
Advertisement
Table of Contents
