Commands In This Section - Dell N1100-ON Reference Manual

port. In this way, the root guard enforces the position of the root bridge. In
MSTP scenario the port may be designated in one of the instances while
being alternate in the CIST, and so on. Root guard is a per port (not a per port
per instance command) configuration so all the MSTP instances this port
participates in should not be in root role.
STP BPDU Filtering - STP BPDU filtering applies to all operational edge
ports. An Edge Port is supposed to be connected to hosts that typically do not
generate BPDUs. Ports on which BDPU filtering is enabled will drop both
transmitted and received BPDUs. As a result, loops may be formed on ports
for which BPDU filtering is enabled.
STP BPDU Flooding - STP BPDU flooding feature applies to an STP
disabled switch. To enable BPDU flooding on a port, STP must be disabled
on the switch administratively. When this feature is enabled on the switch, it
floods all the ports which have the BPDU flood feature enabled.
BPDU Storm Protection - If STP BPDUs are received at a rate of 15 pps or
greater for 3 consecutive seconds on a port, the port will be diagnostically
disabled. A message of the following form is logged:
<188> MAY 04 09:45:23 10.10.10.10-1 DOT1S[276072720]: dot1s_ih.c(1587)
15855515 %% Diagnostically disabling interface 2/0/41
Use the no shut command to return the port to service.

Commands in this Section

This section explains the following commands:
clear spanning-tree
detected-protocols
exit (mst)
instance (mst)
name (mst)
revision (mst)
spanning-tree
backbonefast
spanning-tree bpdu
flooding
spanning-tree
bpdu-protection
spanning-tree cost
spanning-tree
disable
spanning-tree mode spanning-tree priority
spanning-tree mst
configuration
spanning-tree mst
cost
spanning-tree mst
port-priority
spanning-tree mst
priority
Layer 2 Switching Commands
spanning-tree tcnguard
spanning-tree transmit
hold-count
spanning-tree
uplinkfast
spanning-tree vlan
728