Starting The Cli - Dell N1100-ON Reference Manual

Table 2-5. Navigating CLI Command Modes (continued)
Command Mode
VLAN
Tunnel
Loopback

Starting the CLI

To begin running the CLI, perform the following steps:
NOTE:
This procedure is for use on the console line only.
NOTE:
The Easy Setup Wizard may appear if the switch has no user configuration
saved. Follow the procedure in the Getting Started Guide to configure the switch
using the Easy Setup Wizard.
1 Start the switch and wait until the startup procedure is complete and the
User Exec mode is entered. The prompt console> is displayed.
2 Configure the switch and complete any required tasks.
Access Method
From Global
Configuration
mode, use the
interface vlan
command.
From Global
Configuration
mode, use the
interface tunnel
command. Or, use
the abbreviation
interface tu.
From Global
configuration mode,
use the interface
loopback
command. Or, use
the abbreviation
interface lo.
Command Prompt
console(config-if-vlanvlan-
id)#
console(config-tunneltunnel-
id)#
console(config-
loopbackloopback-id)#
Exit or Access
Previous Mode
To exit to Global
Configuration
mode, use the
exit command,
or press
<Ctrl>+<Z>
to Privileged
Exec mode.
To exit to Global
Configuration
mode, use the
exit command,
or press
<Ctrl>+<Z>
to Privileged
Exec mode.
To exit to Global
Configuration
mode, use the
exit command,
or press
<Ctrl>+<Z>
to Privileged
Exec mode.
Using the CLI
244