Dell N1100-ON Reference Manual page 271

Table of Contents

Advertisement

specified name does not exist, and the MAC ACL containing this ACL rule is
applied to an interface or bound to a VLAN, then the ACL rule is applied
immediately. If a time range with the specified name exists, and the MAC
ACL containing this ACL rule is applied to an interface or bound to a VLAN,
then the ACL rule is applied when the time-range with a specified name
becomes active. The ACL rule is removed when the time-range with a
specified name becomes inactive.
Use the no form of the command to delete an existing permit/deny clause.
Syntax
[sequence-number] deny | permit (MAC access-list configuration)
[sequence-number] {deny | permit} {{any | srcmac srcmacmask} {any |
bpdu |dstmac dstmacmask}} [ethertypekey | [0x0600-0xFFFF] [vlan {eq 0-
4095}] [secondary-vlan {eq 0-4095}] [cos 0-7] [log] [time-range time-range-
name] [assign-queue queue-id] [{mirror | redirect} interface-id] [rate-limit
rate burst-size]
no sequence-number
sequence-number—Identifies the order of application of the permit/deny
statement. If no sequence number is assigned, permit/deny statements are
assigned a sequence number beginning at 1000 and incrementing by 10.
Statements are applied in hardware beginning with the lowest sequence
number. Sequence numbers only have applicability within an access group,
i.e. the ordering applies within the access-group scope. The range for
sequence numbers is 1– 2147483647.
srcmac—Valid source MAC address in format xxxx.xxxx.xxxx.
srcmacmask—Valid MAC address bit mask for the source MAC address in
format xxxx.xxxx.xxxx.
any—Packets sent to or received from any MAC address.
dstmac—Valid destination MAC address in format xxxx.xxxx.xxxx.
destmacmask—Valid MAC address bit mask for the destination MAC
address in format xxxx.xxxx.xxxx.
bpdu—Bridge protocol data unit
ethertypekey—Either a keyword or valid four-digit hexadecimal number.
(Range: Supported values are appletalk, arp, ibmsna, ipv4, ipv6, ipx,
mplsmcast, mplsucast, Netbios, novell, pppoe, rarp.)
Layer 2 Switching Commands
271

Advertisement

Table of Contents
loading

This manual is also suitable for:

N1500N3100-onN4000N2100-onN2000N3000

Table of Contents