Auth-Type - Dell N1100-ON Reference Manual

auth-type

Use this command to set the accepted authorization types for dynamic
RADIUS clients. Use the no form of the command to set the authorization
type to the default.
Syntax
auth-type { all | any |session-key}
no auth-type
• all—Selects all COA client authentication types. All authentication
attributes must match for the authentication to succeed.
• any—Selects any COA client authentication type. Any authentication
attribute may match for the authentication to succeed.
session-key—Indicates that the session-key must match for authentication
•
to succeed.
Default Configuration
The default is to authenticate with all parameters.
Command Modes
Dynamic Radius Configuration
User Guidelines
This command specifies the attributes to validate before acting on a CoA or
disconnect request. If session-key is specified and the session ID is valid,
authentication succeeds even if the session-key does not match.
This command works in concert with the ignore command. The ignore
command refines the all parameter to limit the attribute matching.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-radius-da)# auth-type all
Security Commands
969