Table of Contents
Advertisement
•
arp-inspection — Recovery for the dynamic ARP inspection cause is
enabled.
•
dhcp-rate-limit — Recovery for the DHCP rate limit cause is enabled.
•
bcast-storm — Recovery for broadcast storm disabled interfaces is enabled.
•
bpdustorm — Recovery for BPDU storm disabled interfaces is enabled.
•
bpduguard — Recovery for BPDU protection disabled interfaces is
enabled.
•
loop-protect — Recovery for loop protection disabled interfaces is enabled.
•
mcast-storm — Recovery for multicast storm disabled interfaces is
enabled.
•
port-security — Recovery for port security violations is enabled.
•
sfp-mismatch — Recovery for insertion of an unsupported transceiver.
•
sfpplus-mismatch — Recovery for insertion of an SFP+ transceiver in an
SFP port.
•
udld — Recovery for UDLD disabled interfaces is enabled.
•
ucast-storm — Recovery for unicast storm disabled interfaces is enabled.
Default Configuration
No recovery causes are enabled by default.
Command Mode
Global Configuration mode
User Guidelines
Error disabled interfaces indicate that a problem occurred that must be
resolved by the administrator. This could be a configuration problem or a
physical problem (wiring) and does not necessarily indicate a problem with
the switch.
This command enables auto-recovery of an interface for the specified cause
(e.g., bpduguard) or all causes. An interface in the disabled state due to the
configured cause is recovered (link up) when the recovery interval expires. If
Layer 2 Switching Commands
490
Advertisement
Table of Contents
