Password (User Exec) - Dell N1100-ON Reference Manual

console(config-ias-user)#password F81F3CCCB157
console(config-ias-user)#exit
console(config)#

password (User Exec)

Use the password command in User Exec mode to allow a currently logged in
user to change the user password without having read/write privileges. This
command should be used after the password has aged. The user is prompted
to enter the old password and the new password. The special characters
allowed in the password include ! # $ % & ' ( ) * + , - . / : ; < = > @
[ \ ] ^ _ ` { | } ~. User names can contain blanks if the name is
surrounded by double quotes.
NOTE:
For commands that configure password properties, see Password
Management Commands.
Syntax
password
Default Configuration
There is no default configuration for this command.
Command Mode
User Exec mode
User Guidelines
This command configures the password for a switch administrative user.
Example
The following example shows the prompt sequence for executing the
password command.
console>password
Enter old password:********
Enter new password:********
Confirm new password:********
869
Security Commands