Remote-Span - Dell N1100-ON Reference Manual

console(config)#monitor session 1 destination remote vlan 723 reflector-port
Te1/0/1
console(config)#monitor session 1 mode
console(config)#show monitor session 1
Session
Admin mode
Type
Source ports
Both
Destination port
Destination RSPAN VLAN : 723
This example shows how to configure a destination switch using VLAN 723 as
the source RSPAN VLAN interface Te1/0/1 and Gi1/0/10 as the destination
interface. Interface Gi1/0/10 is dedicated to monitoring and has a PC running
WireShark attached. VLAN 723 should only be configured on interface
Te1/0/1.
console(config)#vlan 723
console(config-vlan723)#remote-span
console(config-vlan723)#exit
console(config)#interface Te1/0/1
console(config-if-Te1/0/1)#switchport mode trunk
console(config-if-Te1/0/10)#exit
console(config)# monitor session 1 source remote vlan 723
console(config)# monitor session 1 destination interface gi1/0/10
console(config)# monitor session 1 mode
console(config)#show monitor session 1
Session
Admin mode
Type
Source RSPAN VLAN
Destination port
Command History
Revised in firmware release 6.3.6.

remote-span

Use this command to configure a VLAN as an RSPAN VLAN. Use the no
form of the command to remove the remote SPAN characteristics from a
VLAN and revert it to a normal MAC learning VLAN.
: 1
: Enabled
: Remote source session
:
: Gi1/0/48
: Te1/0/1
: 1
: Enabled
: Remote destination session
: 723
: Gi1/0/10
Layer 2 Switching Commands
650