Dell N1100-ON Reference Manual page 211

Command
connect
cut-through mode
exit
hardware profile
portmode
hostname
initiate failover
load-interval
locate
logout
member
memory free low-
watermark
nsf
ping
process cpu threshold
quit
reload
set description
slot
Description
Connects to the serial console of a different
stack member.
Enables cut-through mode on the switch (if
supported).
Disconnects the serial connection to the remote
unit.
Configures a 40G port in 4x10G mode or
1x40G mode.
Specifies or modifies the switch host name.
Forces failover of management unit.
Loads the interface utilization measurement
interval.
Locates a switch by LED blinking.
Disconnects the serial connection to a remote
unit on a stack member.
Preconfigures a stack member.
Configures the notification of a low memory
condition on the switch for the issuance of the
CPU overload SNMP trap and notification via a
SYSLOG message.
Specifies non-stop forwarding.
Sends ICMP echo request packets to another
node on the network.
Configures the rising and falling thresholds for
the issuance of the CPU overload SNMP trap
and notification via a SYSLOG message.
Disconnects the serial connection to the remote
unit on a stack member.
Reloads the operating system.
Associates a text description with a switch in
the stack.
Configures a slot in the system.
Dell EMC Networking CLI
a
Mode
PE
GC
UE
IC
GC
GC
IC
PE
UE
SG
GC
GC
UE
GC
UE
PE
SG
GC
211