Source-Ip - Dell N1100-ON Reference Manual

source-ip

Use the source-ip command in RADIUS Server Configuration mode to
specify the source IP address to be used for communication with RADIUS
servers. 0.0.0.0 is interpreted as a request to use the IP address of the outgoing
IP interface.
Syntax
source-ip source
• source — A valid source IP address.
Default Configuration
The IP address is of the outgoing IP interface.
Command Mode
RADIUS Server Configuration mode
User Guidelines
The administrator must enter the mode corresponding to a specific RADIUS
server before executing this command.
Example
The following example specifies 10.240.1.23 as the source IP address.
console(config)#radius-server host 192.143.120.123
console(config-auth-radius)#source-ip 10.240.1.23
timeout
Use the timeout command in RADIUS mode to set the timeout value in
seconds for the designated RADIUS server.
Syntax
timeout timeout
• timeout — Timeout value in seconds for the specified server. (Range: 1-30
seconds.)
Security Commands
940