Table of Contents
Advertisement
Example
The following example displays adding a match condition based on the "ip"
protocol name keyword.
console(config-classmap)#match protocol ip
match source-address mac
Use the match source-address mac command in Class-Map Configuration
mode to add to the specified class definition a match condition based on the
source MAC address of the packet.
This command is not available on the N1500 Series switches.
NOTE:
Syntax
match source-address mac address macmask
•
macaddr — Specifies any valid layer 2 MAC address formatted as six two-
digit hexadecimal numbers separated by colons.
•
macmask — Specifies a layer 2 MAC address bit mask formatted as six
two-digit hexadecimal numbers separated by colons. This bit mask does
not need to be contiguous.
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example adds to the specified class definition a match
condition based on the source MAC address of the packet.
console(config-classmap)# match source-address mac 10:10:10:10:10:10
11:11:11:11:11:11
Layer 2 Switching Commands
692
Advertisement
Table of Contents
