Dell N1100-ON Reference Manual page 265

Table of Contents

Advertisement

IPv4 protocols: eigrp, gre, icmp, igmp, ip, ipinip, ospf, tcp, udp, pim,
arp, sctp
number: a protocol number in decimal, for example, 8 for EGP
every: Match any protocol (don't care)
srcip srcmask | any | host srcip—Specifies a source IP address and
netmask to match for the IP ACL rule.
Specifying "any" implies specifying srcip as "0.0.0.0" and srcmask as
"255.255.255.255" for IPv4.
Specifying "host A.B.C.D" implies srcip as "A.B.C.D" and srcmask as
"0.0.0.0".
[{{eq | neq | lt | gt} {portkey | number} | range startport endport}]—
Specifies the layer 4 source or destination port match condition for the
TCP/UDP ACL rule. When the protocol is SCTP, TCP or UDP, a source or
destination port number, which ranges from 0-65535, or a portkey, which
can be one of the following keywords: domain, echo, ftp, ftp-data, http,
smtp, snmp, telnet, tftp, www, bgp, pop2, pop3, ntp, rip, time, who may be
entered. Each of these keywords translates into its equivalent destination
port number.
When "range" is specified, IP ACL rule matches only if the layer 4
port number falls within the specified port range. The startport and
endport parameters identify the first and last ports that are part of the
port range. They have values from 0 to 65535. The ending port must
have a value equal or greater than the starting port. The starting port,
ending port, and all ports in between will be part of the layer 4 port
range.
When "eq" is specified, IP ACL rule matches only if the layer 4 port
number is equal to the specified port number or portkey.
When "lt" is specified, IP ACL rule matches if the layer 4 destination
port number is less than the specified port number or portkey. It is
equivalent to specifying the range as 0 to <specified port number –
1>.
When "gt" is specified, IP ACL rule matches if the layer 4 destination
port number is greater than the specified port number or portkey. It is
equivalent to specifying the range as <specified port number + 1> to
65535.
Layer 2 Switching Commands
265

Advertisement

Table of Contents
loading

This manual is also suitable for:

N1500N3100-onN4000N2100-onN2000N3000

Table of Contents