T1 Csu And Dsx Option Settings And Defaults - Zhone IMACS 8000 User Manual

Running Head
WAN Card User Screens and Settings
Table 9-3. T1 CSU and DSX Option Settings and Defaults
Parameter
STATE
MODE
FORMAT
LINE CODE
PULSE
LINE LEN
SLIP LIM
AIS/ALM
LINE LB
LOCAL LB
CH LB
LB ADDR
LB GEN
LB DET
ESF/NMS RP
EER THRHD
RDNT RULES
GROUP
Notes:
1. The only valid option for Cross-Connect systems is xcon.
2. These options are valid only if you have a CSU and the Line Code is ami. If you have
a CSU and the Line Code is b8zs, then this setting will default to n/a. If you have a
DSX module, then this setting will always default to n/a.
3. These options are valid only if you have a CSU. If you have a DSX module, then the
possible options are 0 (default), 133, 266, 399, 533, 655, and csu.
4. The settings for AIS/ALM are affected by the setting of Group.
5. If the format is d4 or slc96, the only option to appear will be none.
6. If there is no redundant WAN card in the appropriate slot the only option that will
appear is n/a.
7. Selection of GROUP is a two-step process. After identifying the group number (1-4),
the user must select the secondary group (A, B, or C). At which point TCODR will then
become available.
9-22
User Options
stdby actv
xcon
d4 esf slc96 slcd4
ami b8zs
n/a trnsp z15s
0 7.5 15.0
126 138
none tcodr
off on
off on
off clr
01-24
off llb plb nlb
w/to off on
none at&t ansi c-fdl
10e-4 thru 10e-9 none
n/a none OOS CGA
none 1 2 3 4
c-b7r e-fdl
Model No.
WAN Card
Notes Default
stdby
1 xcon
esf
2 b8zs
n/a
3 0
126
4 none
off
off
off
01
off
w/to
5 at&t
10e-4
6 none
7 none
System Cards