Disclaimer For Shielded Cables; Panel And Cover Removal - Zhone IMACS 8000 User Manual

10. DO NOT allow anything to rest on the power cord and do not locate the product
where persons could step on or walk on the power cord.
11. DO NOT attempt to service this product yourself. Refer all servicing to qualified
service personnel.
12. Special cables, which may be required by the regulatory inspection authority for the
installation site, are the responsibility of the customer.
13. When installed in the final configuration, the product must comply with the applicable
Safety Standards and regulatory requirements of the country in which it is installed.
If necessary, consult with the appropriate regulatory agencies and inspection
authorities to ensure compliance.
14. A rare phenomenon can create a voltage potential between the earth grounds of two
or more buildings. If products installed in separate buildings are interconnected, the
voltage potential may cause a hazardous condition. Consult a qualified electrical
consultant to determine whether or not this phenomenon exists and, if necessary,
implement corrective action prior to interconnecting the products.
This equipment has been tested and found to comply with the limits for a Class
"A" Digital Device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy, and, if not installed
and used in accordance with this Reference Guide, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user
will be required to correct the interference at their own expense.
The authority to operate this equipment is conditioned by the requirement
that no modifications will be made to the equipment unless the changes or
modifications are expressly approved by the manufacturer.
A.9.1 Disclaimer for Shielded Cables
This equipment was tested with shielded input/output and interface cables. It is recommended
that shielded cables be used to reduce interference whenever interference is suspected.
A.9.2 Panel and Cover Removal
Only qualified service technicians should attempt the removal of covers and panels.
Reference Guide
WARNING!
A-21