Installing Dsx/Cept Modules - Zhone IMACS 8000 User Manual

WAN Card
First, install a DSX/CEPT module in the slot reserved for WAN port 1-1. Insert the pins for
TX into socket JP10 on the WAN card (see Figure 9-10), while also inserting the pins for RX
in JP9 and the 24-pin end connector pins in JP6. Then, for a WAN DUAL card, install another
DSX/CEPT module in the WAN port 1-2 location, and plug that module into JP13, JP14, and
JP15.
JP14 JP15
JP13
JP6
JP10
Figure 9-10.Installing DSX/CEPT Modules (8010)
System Cards
WAN Module Descriptions
9-15