Tcp/Ip Screen Actions; Tcp/Ip Screen Options And Defaults - Zhone IMACS 8000 User Manual

Running Head
TCP/IP Network Management
Action
Ping
Netstat
rOute
Save
Undo
Refresh
nX64
sysLog
Main
Parameter
HOST IP STATE
HOST IP ADDR
HOST NETMASK
HOST TYPE
DEFAULT IP PORT
DEFAULT IP SLOT
DEFAULT IP UNIT
RPT1 IP ADDR
RPT1 COMMUN STR
RPT2 IP ADDR
RPT2 COMMUN STR
RPT3 IP ADDR
RPT3 COMMUN STR
HOST IP STATE
This parameter determines whether TCP/IP is active or inactive. This is the master switch for
the host IP stack, and is required to be set active in order for any IP communication to go
through. The HOST IP STATE defaults to stdby (standby) prior to configuration. You must
set it to actv (active) to enable TCP/IP.
7-20
Table 7-5. TCP/IP Screen Actions
Test whether the connected device responds to an echo request message.
After entering the IP address of the host device, the status line will display,
"Testing . . ." The next message indicates if the host is alive or down.
Displays the Network Statistics. See below.
Shows the Routing screen. See the "Routing" section below.
Saves changes to settings.
Returns all settings to the last saved state.
Used on Testing and Monitoring screens to update statistics, and on other
screens to redraw the screen.
Used for nx64 kbps HDLC/FR connectivity to other Integrated Access
Systems as well as directly connecting to the MCC, IPR, FR at nx64 kbps.
Access to turn on or off the syslog feature
Returns to the CPU card main screen. If changes are made to settings and
not saved, you will be prompted to save or lose changes.
Table 7-6. TCP/IP Screen Options and Defaults
stdby actv
IP address
Network
host gateway
none local
n/a local wan (w1, w2, w3, w4) servr
(P1, P2, P3) nx64
n/a 1-2 C1 C2 C3 C4
IP address
IP address
IP address
Function
User Options
wan servr nX64
Model No.
CPU Card
Default
stdby
0.0.0.0
0.0.0.0
host
none
n/a
n/a
0.0.0.0
blank
0.0.0.0
blank
0.0.0.0
blank
System Cards