Electrostatic Discharge Prevention; Operator Services Requirements; Regulatory Compliance Information; Fcc Part 68 Information - Zhone IMACS 8000 User Manual

DO NOT Stack Units on top of one another. There MUST be at least 1"
clearance between units.
A.10.2 Electrostatic Discharge Prevention
The plug-in cards contain components that could be damaged by electrostatic discharge.
When handling any cards, wear a properly grounded wrist strap to prevent possible card
damage, or follow other suitable precautions to prevent equipment damage.
A.10.3 Operator Services Requirements
This equipment is capable of giving users access to interstate providers of operator services
through the use of equal access codes. Modifications by aggregators to alter these capabilities
may be in violation of the Telephone Operator Consumer Services Improvement Act of 1990
and Part 68 of the FCC Rules.
A.11 Regulatory Compliance Information
A.11.1 FCC Part 68 Information
This equipment complies with Part 68 of the FCC rules.
The equipment has FCC Registration Number 1H5SNG-73866-DD-E. This equipment uses
the following USOC jacks: RJ11C, RJ21X, RJ2EX, RJ2FX, RJ2GX and RJ2HX.
The Ring Equivalence Number (REN) is used to determine the quantity of devices that may
be connected to the telephone line. Excessive RENs on the telephone line should not exceed
five (5). To be certain of the number of devices that may be connected to the line, as
determined by the total RENs, contact the telephone company to determine the maximum
RENs for the calling area.
If this equipment causes harm to the telephone network, the telephone company will notify
you in advance that temporary discontinuance of service may be required. If advance notice
is not practical, the telephone company will notify you as soon as possible. Also, you will be
advised of your right to file a complaint with the FCC if you believe it is necessary.
Reference Guide
Notice!
Passive Cooling Requirements
A-23