Test Screen Option Settings And Defaults - Zhone IMACS 8000 User Manual

Running Head
FXS Card User Screens and Settings
Table 12-8. Test Screen Option Settings and Defaults
Parameter
SIG MON
TEST
Tx ABCD
Rx ABCD
T-R-CNTL
TO USER
TO NTWK
Tx ABCD
Rx ABCD
T-R-CNTL
T-R-STAT
MODE
TYPE
STATUS
SIG MON
The Signaling Monitor feature works with the user card alarm system to detect excessive
signaling bit transitions. The system will generate alarms if the number of transitions of any
signaling bit in transmit or receive direction for an active port exceeds 255 in any four second
interval. The options are off and on, and they are toggled by pressing "g" (siGmon command)
in the Test Screen.
TEST
The Test parameter shows if the port is in test mode or not. Inactive ports and ports that are
assigned to inactive WANs will show a test status of n/a. The test status options for active
ports are off and on.
Tx ABCD
The Transmit ABCD setting allows the user to either monitor the status of the ABCD signaling
bits being transmitted towards the network or set a specific ABCD pattern for testing the
transmit side of the circuit. The options for this field are mon (monitor) or set. Choosing set
will bring up a four digit field for users to input the ABCD pattern they want to transmit. Any
four-digit combination of ones and zeros is acceptable for this setting.
12-14
User Options
off on
off on
mon set
mon set
mon set
PCM 300Hz 1kHz
PCM 300Hz 1kHz
Status information only; not editable
Status information only; not editable
Status information only; not editable
Status information only; not editable
Status information only; not editable
Status information only; not editable
Status information only; not editable
off
off
mon
mon
mon
3kHz quiet PCM
3kHz quiet PCM
n/a
n/a
n/a
n/a
n/a
n/a
n/a
Model No.
FXS Card
Default
Voice Cards