FXS Card
12.2.1.2 Installing the FXS 2W*8-6 Card
Install the FXS 2W*8-6 Card in any user card slot. These slots are U1 to U8 on the two-sided
chassis and front-loading chassis with power supplies on top, or P1 to P4 and W1 to W4 on
the front-loading chassis with power supplies on the side.
12.3 FXS Card User Screens and Settings
12.3.1 FXS Card Main Screen
You must configure the FXS card for operation after installing it into the system chassis. This
is done from the FXS Card Main Screen (see Figure 12-2). To go to that screen, highlight the
desired card in the System Main Screen and press <Enter>. This screen shows one
configuration column for each port on the card.
The bottom highlighted line of this screen shows various actions that you can perform from
this screen. You perform the desired action by pressing the associated uppercase letter key.
Table 12-1 summarizes these actions. For example, after you configure the FXS card ports,
press "s" to save your settings.
Voice Cards
Figure 12-2.Typical FXS Card Main Screen
FXS Card User Screens and Settings
12-3