Wan Dual Card Description (801060, 801065) - Zhone IMACS 8000 User Manual

WAN Card
Note: NOTE: The card will automatically restart to activate the new load. Once the
XMODEM process has completed, the card will take an additional 30 seconds to
complete. The user will be notified of a successful XMODEM download by the
generation and clearing of a WAN OOS alarm.
Assuming this checksum operation passes, the card will automatically perform a restart
operation and install the new load. Watching the alarm banner in the upper-right screen should
display the WAN going OOS and then that alarm clearing. This indicates that the card is now
running the new load, and has been successfully written to flash. To validate this, the user
would need to exit and re-enter the download screen to see the new information. The load
displayed should now reflect the information from the load sent over via the XMODEM
process. Alternatively, the user could go back to the serialization screen to observe the load
running on the WAN card (seen in Figure 1 at the beginning of this procedure). Should the
checksum function not pass, then the user will be prompted to try the download action again.
Once the downlaod has completed or failed, then the system will clear the UPGRADE alarm.
9.2.2

WAN DUAL Card Description (801060, 801065)

The WAN DUAL card connects to two T1 or E1 lines, or to one of each type. The works with
only one DSX/CEPT or CSU plug-in module if the WAN port without either module remains
in the standby state (see Figure 9-9). However, a CGA-Red alarm will be generated for that
port. The WAN DUAL (801060) card works with DSX/CEPT module (81130) and CSU
Module (81230) referred to later in this section.
System Cards
WAN Card Descriptions
9-11