Chapter 18 Ds0-Dp Card; Introduction; Ds0-Dp Card Description; Ds0-Dp 4 Card Description (8000-Ds0Dp-4P) - Zhone IMACS 8000 User Manual

DS0-DP Card
Chapter 18
DS0-DP Card

18.1 Introduction

This chapter provides installation, configuration, and troubleshooting information for the DS0
Dataport (DS0-DP) Card. This card is labeled as the DS0-DP 4 card on its faceplate ejector.

18.2 DS0-DP Card Description

18.2.1 DS0-DP 4 Card Description (8000-DS0DP-4P)

The DS0-DP 4 Card Contradirectional/Codirectional Data Unit (DS0-DP/G.703) provides a
64 kbps interface to a DS0 time slot of a T1 or E1 network. Since the byte alignment of the 64
kbps data stream to the time slot is essential, the interface provides a 64 kbps bit clock and an
8 kHz byte clock in the DS0-DP mode.
OPERATION OF THIS INTERFACE IS LIMITED TO INTRA-BUILDING

18.2.1.1 Card Jumper/Switch Settings

The DS0-DP 4 Card does not have any jumpers or switches on its mainboard.

18.2.1.2 Installing the Card

Install the DS0-DP 4 Card into any user card slot. These slots are U1 to U8 on the two-sided
chassis and front-loading chassis with power supplies on top, and P1 to P4 or W1 to W4 on
the front-loading chassis with power supplies on the side.
Data Cards
Notice!
UL STATEMENT
CONNECTIONS ONLY
Introduction
18-1