Typical Adpcm Card Main Screen - Zhone IMACS 8000 User Manual

System Configuration and Operation
To choose a redundant ADPCM card for the system, proceed as follows:
1. Go to the System Main Screen (if you are not already there).
2. Select the desired ADPCM card from the System Main Screen, and press <Enter> to
go to the Main Screen of that card. Figure 5-82 shows the card in slot P1 is chosen.
3. Highlight the STATE parameter of any ADPCM port on the card, and press the <Enter>
key. This changes the STATE setting to rdnt. The entire ADPCM card now becomes the
redundant ADPCM card for the system once the change has been saved.
Reference Guide
Figure 5-82.Typical ADPCM Card Main Screen
ADPCM Card Redundancy
5-101