Main Screen Actions; Main Screen Option Settings And Defaults - Zhone IMACS 8000 User Manual

Running Head
FXO Card User Screens and Settings
Action
Save
Undo
Refresh
Copy
Test
Main
Table 13-2 summarizes the configuration settings for the FXO card, along with the available
and factory-default option settings. The parameters and settings are also described in the
following paragraphs.
Table 13-2. Main Screen Option Settings and Defaults
Parameter
STATE stdby
WAN/SRV none wan serv
TS 01-24
MODE fxo
SIGNAL loop
Rx TLP -10.0 dB to +2.0 dB
Tx TLP -10.0 dB to +5.0 dB
CODING u-law
TC CGA idle
LB off
PATTERN none
HYBRID set1 to set8
WK DLY 00-99
WINK 00-199
SIG CONV off
RATE 64K
ADPCM n/a
OHD TOUT 1600ms - 3300ms
Notes:
1. Choosing wan allows you to choose a WAN port (w1-1 through w4-2). Choosing serv
lets you choose an ADPCM server card in slot P1, P2, or P3, followed by a logical port
on that card. If your system has the FRS card installed and you want to use voice
compression you need to install the Low Bit Rate Voice (LBRV) card. However, if your
system has the ATM card installed you can proceed directly with voice compression (there
is no need for the LBRV Card to be installed.) The user option is not used. See the
WAN/SRV paragraph that follows.
13-4
Table 13-1. Main Screen Actions
Saves changes to settings.
Returns all settings to the last saved state.
Updates certain time-related information fields that are not automatically
updated (i.e., test status).
Copies the contents of the current column to the next column. Useful if you
change a lot of entries in one column and want to repeat those changes in
subsequent columns.
Initiates and monitors testing of all FXO card ports. Refer to the Test section
of this chapter.
Returns to the System Main Screen. If changes are made to settings and not
saved, you will be prompted to save or lose changes.
User Options
actv
user
01-31
fxodn dpt mrd
gs lp-fd 1s-R2 gs-a lp-em
a-law a-inv
busy
dgtl anlg
D-mW quiet
user
on
24K,1 32K,1 40K,1
P1 P2 P3
Function
24K,2 32K,2 40K,2 7
Model No.
FXO Card
Notes Default
stdby
1 w1-1
2 01
fxo
3 loop
0.0
0.0
4 u-law
idle
off
none
5 set1
6 0
6 0
off
64K
n/a
8 3300ms
Voice Cards